Bend Radius
Get Bend Radius essential facts below. View Videos or join the Bend Radius discussion. Add Bend Radius to your PopFlock.com topic list for future reference or share this resource on social media.
Bend Radius

Bend radius, which is measured to the inside curvature, is the minimum radius one can bend a pipe, tube, sheet, cable or hose without kinking it, damaging it, or shortening its life. The smaller the bend radius, the greater is the material flexibility (as the radius of curvature decreases, the curvature increases). The diagram to the right illustrates a cable with a seven-centimeter bend radius.

Cable with a seven-centimeter bend radius

The minimum bend radius is the radius below which an object such as a cable should not be bent.

Fiber optics

The minimum bend radius is of particular importance in the handling of fiber-optic cables, which are often used in telecommunications. The minimum bending radius will vary with different cable designs. The manufacturer should specify the minimum radius to which the cable may safely be bent during installation, and for the long term. The former is somewhat larger than the latter. The minimum bend radius is in general also a function of tensile stresses, e.g., during installation, while being bent around a sheave while the fiber or cable is under tension. If no minimum bend radius is specified, one is usually safe in assuming a minimum long-term low-stress radius not less than 15 times the cable diameter, or 2 inches.[1]

Beside mechanical destruction, another reason why one should avoid excessive bending of fiber-optic cables is to minimize microbending and macrobending losses. Microbending causes light attenuation induced by deformation of the fiber while macrobending causes the leakage of light through the fiber cladding and this is more likely to happen where the fiber is excessively bent.

Other applications

Strain gauges also have a minimum bending radius. This radius is the radius below which the strain gauge will malfunction.

For metal tubing, bend radius is to the centerline of tubing, not the exterior.

References

  1. ^ "StackPath". www.cablinginstall.com. Retrieved .

Public Domain This article incorporates public domain material from Federal Standard 1037C. General Services Administration. Archived from the original on 2022-01-22.


  This article uses material from the Wikipedia page available here. It is released under the Creative Commons Attribution-Share-Alike License 3.0.

Bend_radius
 



 



 
Music Scenes